Measuring Guides for Kilts, Trousers and Jackets

For many, the thought of self measuring for Highland dress may seem quite daunting, but by following a few basic instructions, this need not cause concern.

There are two golden rules.

1. DO NOT attempt to do this alone. It is essential that you get someone else to do the measuring as it is quite impossible to do this yourself with any degree of accuracy.
   
   
2. Use a proper tailor’s measuring tape. This may sound obvious but you’d be amazed at the number of folk who try to make do with a 6 inch ruler and a piece of string! It never works

Finally, if you need any advice, or are not sure of something, don’t hesitate to contact our sales team at 01896 208 007.

KILT MEASURING GUIDE

Waist Measurement (d): To accurately measure the waist, begin 2 inches above the hip bone, typically at the navel. Tighten the measuring tape around the stomach from this point.
Note that this waist measurement differs from trouser waist measurements, as kilts are worn higher, resulting in a usually greater measurement than trouser waistlines.

Seat Measurement (e): Measure the widest area across the bottom by loosely wrapping the tape measure around.
Avoid pulling the tape tight; this measurement should be comfortably loose.

Kilt Length or Drop (f): While kneeling on the floor with an upright posture and looking straight ahead, measure from the navel to the floor. This provides the correct finished length, typically at mid-knee.
It's important not to lean forward to view the measurement, as this can lead to inaccuracies.
Additionally, it's essential to have someone else take the measurement for you, as accurately measuring oneself is practically impossible.

 

JACKET MEASURING GUIDE

Chest Measurement (b): Start by measuring around the fullest part of your chest, typically just under your armpits. Make sure the tape measure is snug but not too tight. This measurement will determine the size of your jacket.

Waist Measurement (d): Measure around your natural waistline, which is usually the narrowest part of your torso. This measurement ensures that the jacket fits well around your waist.

Sleeve Length (c): Measure from the outer edge of your shoulder down to where you want the sleeve to end. Typically, this is at the base of your thumb. Ensure your arm is relaxed and slightly bent when taking this measurement

Neck Measurement (a): Wrap the tape measure around the base of your neck where the collar usually sits. Make sure it's snug but not tight. This measurement determines your collar size

Additionally, considering the size label and fitting of any existing jackets can provide insight into the size you may require..

 

TREWS MEASURING GUIDE

Waist Measurement (d): Start by finding your waist measurement. This is typically done by wrapping a tape measure around your waist at the level where you usually wear your pants.
Make sure the tape is snug but not too tight. This will give you the waist size for your trews.

Seat Measurement (e): Measure around the fullest part of your thigh while standing with your legs slightly apart. This ensures that the trews will fit comfortably around your thighs without being too tight.

Inside Leg Measurement (g): Measure from the crotch area down to where you want the trews to end. For most people, this is typically at the ankle bone or slightly above. Make sure you stand straight while taking this measurement.

Outside Leg Measurement (h): Measure from the waist down to where you want the trews to end. Again, this is usually at the ankle bone or slightly above. Ensure you stand straight while measuring.

Remember to use a flexible tape measure and stand in a relaxed posture while taking these measurements. It's also a good idea to have someone assist you for more accurate results. Once you have these measurements, you can confidently order or purchase tartan trews that fit you perfectly.

 

Remember, if you need any advice, or are not sure of something, don’t hesitate to contact our sales team at 01896 208 007.